"Jet-Stream" Showerhead^®

2-Minute Installation Guide

The "Jet-Stream" Showerhead^® fits all standard ½-inch threaded shower arms (Adaptors are available to retrofit obsolete ball-type shower arms).

1. Remove the current showerhead from the shower arm extension, by hand or by using a crescent or pipe wrench.
2. Remove all grime or dirt from the shower arm extension with a rag or cloth. Wrap with plumbing tape if necessary to provide a smooth and clean connection.
3. Install The "Jet-Stream" Showerhead^® and ensure the black seal is centered in the top of the connector before installing, turning the connector clockwise until snug. Caution: do not over-tighten as this may damage the seal.
4. Turn on the water and ensure there are no leaks. Tighten as necessary by hand or with a wrench. Do not over-tighten as damage to the seal may occur and the showerhead will not perform as designed.